The main function of the reducer:

　　The eccentric reducer factory believes that reducing the motor speed and increasing the output torque, the combined output torque of the motor and the reducer is the motor torque multiplied by the reducer ratio of the reducer multiplied by the work efficiency. It should be noted that the motor torque multiplied by the reduction ratio should be less than the speed reduction. the rated torque of the machine.

　　The eccentric reducer factory takes you to understand the working principle of the reducer:

　　The principle of the reducer is to use large and small gears to work. Since the teeth of the input gear shaft mesh with the large gear on the output shaft, the number of teeth of the input gear shaft is less than the number of teeth of the large gear on the output shaft, according to the number of teeth. The ratio is inversely proportional to the number of revolutions. After being transmitted to the output shaft through the input gear shaft, the output shaft obtains a low-speed motion lower than the input shaft.

　　How to maintain the reducer in the eccentric reducer factory:

　　1. The planetary reducer of the eccentric reducer factory adopts a sealed design, and the fuselage can reach the IP65 protection level, so the planetary reducer can achieve a life-long maintenance-free state.

　　2. The joint reducer of the eccentric reducer factory will not add lubricating oil unless there are special circumstances at the factory. The amount of lubricating oil must be added according to the manufacturer's standard. The lubricating oil of the joint reducer has a service life.

　　3. Before the turbine reducer of the eccentric reducer factory leaves the factory, the manufacturer usually adds a certain amount of lubricating oil. When the turbine reducer runs at a high speed for a long time, it needs to be replaced with a vent cap. The working oil will volatilize for a long time, so it is necessary to observe and reduce oil. Just add it.