Trochoidal eccentric reducer heat check

　　The noise of the cycloid eccentric reducer is inherently large. If you feel that the noise is loud, but the oil temperature has not changed, it generally does not matter, or check the noise value and call the eccentric reducer manufacturer to inquire whether the noise value is normal. value.

　　The lubrication problem of eccentric reducer often leads to the problem of heat and noise of the reducer. If there is too much lubricating oil, the oil will lose power and generate a lot of heat. If there is too little lubricating oil, friction will also generate a lot of heat.

　　For the reducer used for stirring, the cycloid eccentric reducer should generally be installed vertically. In this case, the small type reducer is generally grease lubricated. Please confirm that the amount of grease injection meets the manufacturer's requirements; the large type is generally forced lubrication, confirm the lubrication Whether the pipeline is blocked.

　　Whether the alignment between the eccentric reducer and the driven shaft is beyond the required range. If the alignment is not good, it will cause the output bearing of the reducer to be subjected to excessive radial force. A lot of heat, the eccentric body bearing is the weak link in the cycloid eccentric reducer, and its quality is very important.

　　Reassembly, the accuracy is difficult to guarantee! There is a problem with the reducer itself, and the machining accuracy is very low, resulting in poor meshing between the curved plate and the pin gear pin. The curved plate is the core component of the cycloid eccentric reducer, and the general low-quality manufacturers use it There is no special machine tool for wire cutting and tooth grinding, or the use of modified machine tools, resulting in low precision, causing a lot of noise and generating a lot of heat.