Common fault causes and general solutions for heating of worm gear eccentric reducer

　　Worm gear eccentric reducer may be caused by the fact that the conveyor belt is not fixed, resulting in increased friction of the worm, serious wear of the inner shaft, and serious solid heat.

　　The worm gear eccentric reducer checks whether the oil circuit is damaged, whether there is a problem with the seals or if the oil is too low, and the oil mark is damaged. If this is the reason, the oil plug should be replaced, the oil should be injected to the specified parameters, and the seals should be glued to repair the leakage, etc.

　　The worm gear eccentric reducer checks whether there is foreign matter intrusion that causes the deformation and damage of the worm gear and worm, then open the casing, and use a powerful vacuum cleaner to suck up the debris. It is also possible that the worm gear and the worm gear do not match, the shaft clearance is too large, and the lubricating oil is too small. The solution: Grind the gear surface to make it fit, add appropriate amount of lubricating oil according to the instructions, and check whether the engine is normal.

　　The running time of the worm gear eccentric reducer is too long, which leads to the aging of the circuit parts. Replace the circuit parts that have problems, and properly control the use time. After a period of continuous operation, the machine should be stopped.